Online Support Centre

Installing the Thomson TG123g Wireless Adapter - Windows Vista

Here we'll show you how to install the Thomson TG123g Wireless Adapter on Windows Vista.

  1. Introduction
  2. Before you start
  3. Installing and connecting the TG123g
  4. Connecting to your Wireless Network

Introduction

Your hardware pack contains:

Box contents

Before you start

Only plug your adapter in when the installation software tells you to.

Installing and connecting the TG123g

1. Put the TG123g Setup CD into your CD drive,

CD in drive

2. An AutoPlay window will appear on your screen.

Click Run setup.exe to begin setup. At this point you might see another pop-up asking you to confirm that you want to run the software. Click Allow to continue.

Autoplay

2. Choose your language and click OK.

Choose Language

3. You'll see the setup Welcome Screen, click Next.

Setup Welcome

4. You'll be asked to check that everything you need is in the box, click Next. Now you'll see the Safety Instructions and Regulatory Notices. When you've read these and you're happy with them, tick the box labelled I have read and fully understand the Safety Instructions and Regulatory Notices and press Next.

Saftey notes and Terms

5. The software for your Thomson TG123g Wireless Adapter will now be installed.

Software Install

6. Now it's time to plug in the adapter. Open the lid and plug the adapter into a USB port on your computer and click Next.

Plug in adapter

7. You'll see a pop up at the bottom of your screen, this means that your computer has detected the adapter.

Installing pop-up

8. When it's finished you'll see this screen, press Finish to close the setup wizard

Done

 

Connecting to your wireless network

1. Now the adapter is installed, you'll see a wireless network icon in your system tray (you can find this in the bottom right-hand corner of your screen). Right click on it and choose Connect to a Network.

Network Icon

2. Your computer will scan and show you the networks you can connect to, if you don't see anything click the refresh button.

Click on your network so it's highlighted and press Connect. On the Thomson 585v7 router, the name of the wireless network is the SSID which you'll find printed on the bottom of the router.

Available Networks

3. If you're connecting to your Thomson 585v7 for the first time, enter the WPA PSK key (printed on the bottom of the router) in the Security key or passphrase box and press Connect.

Enter Key

4. Your computer will now connect to the network.

Connect to network

If you've not already done so the next step is to connect your router to the Internet.

If you're using the Thomson 585v7 our Installation guide will show you how.

 


Has this page helped you solve your problem? Your feedback helps us to improve the help we provide.

Rate this page : happy neutral unhappy

Please note: We cannot reply to individual feedback through Rate My Page. If you need more help with a problem please use Contact Us.


Installing the Thomson 585v7 - Windows

Wireless FAQs

Internet Security

Service Status RSS icon

Broadband OK
Email OK
Webspace & FTP OK
Newsgroups OK
Support services OK
My Account OK
  • Informational : General Information
  • Maintenance : Planned Maintenance

Customer Care: 0844 395 0830 or 0345 140 0200 (7 days a week, 365 days a year)
Technical Support: 0844 395 0830 or 0345 140 0200 (7 days a week, 365 days a year)
Calls to our 0844 support number cost 6p per minute plus your phone company's access charge.
Copyright ©Madasafish